Free fence pricing calculator for the MS Gulf Coast. Based on local material and labor rates. No sign-up needed.
Get Your Estimate →Enter your fence dimensions and preferences for an instant price range.
Choose the right material for your Gulf Coast climate.
| Material | Cost/ft (6ft) | Lifespan | Maintenance | Best For |
|---|---|---|---|---|
| Pressure-Treated Pine | $18–22 | 10–15 yrs | Stain every 2–3 yrs | Budget, durability |
| Cedar | $28–35 | 15–20 yrs | Low — seals naturally | Natural look, coastal |
| Vinyl | $35–45 | 25–30 yrs | None — hose it down | Zero maintenance |
| Composite | $40–50 | 25–30 yrs | None | Premium, hurricane winds |
Get accurate measurements for a better estimate.
Walk the property line and measure each straight section. Add them up for total linear feet. Mark corners and gate locations.
Find your survey stakes or plat map. Most fence disputes happen when the fence is 6" over the line. When in doubt, get a survey.
Sandy soil may need deeper post footings (24-36"). High winds mean 4x4 or 6x6 posts set in concrete. Cedar and vinyl hold up best to salt air.
What's different about fencing on the Coast — local materials, soil, and costs.
This calculator uses actual MS Gulf Coast material and labor rates. Pressure-treated privacy fencing runs $18-22/linear ft installed on the Coast. Cedar runs $28-35. Vinyl $35-45. These numbers reflect what local contractors actually charge — not generic national figures.
Within 5 miles of the Coast, standard hardware rusts fast. Use stainless steel or hot-dipped galvanized screws, hinges, and latches. Cedar and vinyl naturally resist salt air better than pressure-treated pine — worth the premium near the beach.
Gulf Coast sand doesn't hold posts like clay. Fence posts need 24-36" depth (vs 18" standard) with 8" diameter concrete footings. For gates and corner posts, go 36" deep with a 10" bell-bottom. Add ~$3-5/post for the extra concrete.
Fences over 6' tall need 4x4 or 6x6 posts set in concrete, with post spacing no wider than 6'. In high-wind zones, use 2x6 top rails instead of 2x4. Panel fences (vinyl, composite) need reinforced rails to survive storm season.
Gulfport: Fences over 6' need a permit. Biloxi: All fences over 4' require a permit + survey. Ocean Springs: Permits required for any fence. Long Beach: No permit under 6' unless it's on a corner lot. Always check before building.
Cedar is the go-to on the Coast — naturally rot-resistant, holds paint well, lasts 15-20 years. Vinyl is gaining popularity (zero maintenance, 25-30 year lifespan). Pressure-treated is budget-friendly but needs staining every 2-3 years in this humidity.
Tell us about your fence project and we'll connect you with a vetted contractor on the MS Gulf Coast.
Find a Contractor →One-time fee. You only pay when we connect you with a qualified contractor.
Supply Match MS